Shure Condenser Lavalier Omni Mic Omni Directional with Preamp, Tie Clip,Screen

Shure Condenser Lavalier Omni Mic Omni Directional with Preamp, Tie Clip,Screen
Camcor Item No.	SHUMX183
Mfg. Part No.	MX183

Provides low handling noise. Pickup angle = 360.

Models MX183, MX184, and MX185 are wired lavalier electret condenser microphones designed for speech and vocal pickup, general purpose sound reinforcement, recording, and remote monitoring applications. They can be clipped to neckties, lapels, and other articles of clothing. Interchangeable cartridges make it possible to easily reconfigure microphone coverage as the need arises.

Features

Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum

Interchangeable cartridges that provide an optimal choice for each application

Rotatable tie-clip that pivots in 90 increments for placement flexibility

Supplied snap-fit foam windscreen that controls breath noise and stays on securely

Balanced, transformerless output for increased immunity to noise over long cable runs

Supplied dual tie clip holds two microphones for dual miking applications

Specifications

Type	Condenser (electret bias)
Frequency Response	50 to 17,000 Hz
Polar Pattern	Omnidirectional
Output Impedance	EIA rated at 150 (180 actual)
Open Circuit Sensitivity (at 1 kHz, ref. 1V/Pascal*)	27.5 dB (42.2 mV) 1 Pascal = 94 dB SPL
Max SPL (1kHz at 1%THD, 1 kO load)	116.7 dB
Equivalent Output Noise (A-weighted)	20.5 dB
Signal to Noise Ratio (referenced at 94 dB SPL)	73.5 dB
Dynamic Range at 1 k load	96.2 dB
Power Requirements	11 to 52 Vdc phantom, 2.0 mA
Common Mode Rejection	45.0 dB minimum
Polarity	Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector.
Environmental Conditions	Operating Temperature Range: -18° to 57° C (0° to 135° F) Storage Temperature Range: -29° to 74° C (-20° to 165° F)
Cable	Shielded 1.2 meter (4 ft.) cable terminated with a 4-Pin Female Mini Connector (TA4F)
Certification	Eligible to bear CE Marking. Conforms to European EMC Directive 89/336/EEC. Meets applicable tests and performance criteria in European Standard EN55103 (1996) parts 1 and 2, for residential (E1) and light industrial (E2) environments.