Shure MX202BP/C Microflex Black Overhead Condenser Mic with 30 ft Cable, Plate-Mounted Preamplifier

Shure MX202BP/C Microflex Black Overhead Condenser Mic with 30 ft Cable, Plate-Mounted Preamplifier
Usually ships in 1-3 business days
Camcor Item No.	136017130
Mfg. Part No.	MX202BP/C

Shure MX202BP/C Microflex Black Overhead Condenser Mic with 30 ft Cable, Plate-Mounted Preamplifier

It is hard to believe that such small, unobtrusive microphones can produce such great sound, but it's true. Available in black or white finishes, and with in line or plate mount preamps, the Microflex® Overhead condenser microphones capture Shure quality sound in a compact, adjustable package. Each model features a choice of interchangeable cardioid, supercardioid and omnidirectional condenser microphone cartridges attached to a flexible, four inch gooseneck with a 30 foot cable. The preamp options available offer easy installation in ceilings or microphone stands, and when combined with the high sensitivity cartridge's wide frequency response, these microphones provide accurate sound reproduction with a minimum of RF interference or electromagnetic hum.

(cc)

Features

Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum

Interchangeable cartridges that provide an optimal polar pattern choice for each application

Balanced, transformerless output for increased immunity to noise over long cable runs

Supplied stand-mount adapter for portable applications (in-line preamplifier versions only)

White or black finish that blends unobtrusively with most surroundings

Specifications

General

Frequency Response	50 to 17,000 Hz
Output Impedance	180 ohms actual (EIA rated at 150 ohms)
Sensitivity (At 1,000 Hz, open circuit voltage*)	-35.0 dBV/Pa (17.8 mV)
Maximum SPL (1 kHz at 1% THD, 1 k ohm load)	124.2 dB
Equivalent Output Noise (A-weighted)	28.0 dB SPL
Signal to Noise Ratio (referenced at 94 dB SPL)	66.0 dB
Dynamic Range at 1 k ohm load	96.2 dB 100 dB at 0 gain
Common Mode Rejection	45.0 dB minimum
Preamplifier Output Clipping Level (1% THD)	-6.0 dBV (0.5 V) -12 dBV at 0 gain
Polarity	Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector.
Power Requirements	11 to 52 Vdc phantom, 2.0 mA
Environmental Requirements	Operating Temperature Range: -18 to 57 degrees C (0 to 135 degrees F) Relative Humidity: 0 to 95%