Shure MX412/C 12" Gooseneck Microphone Condenser Cardioid

Shure MX412/C 12" Gooseneck Microphone Condenser Cardioid
Camcor Item No.	136017172
Mfg. Part No.	MX412/C

Shure MX412/C 12" Gooseneck Microphone Condenser Cardioid

Microflex Standard Gooseneck microphones bring a whole new meaning to the word flexible with their fully adjustable gooseneck. Designed for easy replacement and available in cardioid, supercardioid and omnidirectional polar patterns, the interchangeable cartridges offer wide frequency response and accurate sound reproduction for a wide variety of applications, such as houses of worship, courtrooms and conference centers. Plus, the condenser cartridges fit every model in the Microflex product line for enhanced convenience and consistent sound.

Features

304.8 mm (12 in.) gooseneck

Attached XLR Preamp, Shock Mount, Flange Mount, Snap-Fit Foam Windscreen

Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum

Interchangeable cartridges provide the right polar pattern for every application

Balanced, transformerless output for increased immunity to noise over long cable runs

Shock mount provides over 20 dB isolation from surface vibration noise

Locking flange mount for permanently securing microphone to lecterns, pulpits, or conference tables

Snap-fit foam windscreen

Programmable on/off switch and LED on/off indicator (MX412D/MX418D)

New brighter LED improves visibility under strong ambient lighting (MX412D/MX418D)

Logic input and output terminals for remote control or use with automatic microphone mixers (MX412D/MX418D)

Supplied shock mount for more than 20 dB isolation from surface transmitted noise (MX412SE/MX418SE)

Supplied threaded flange mount for permanently securing the microphone to a lectern, pulpit, or conference table (MX412SE/MX418SE)

Specifications

Specifications
Output Impedance	180 ohms actual (EIA rated at 150 ohms)
Sensitivity (At 1,000 Hz, open circuit voltage*)	-35.0 dBV/Pa (17.8 mV)
Maximum SPL (1 kHz at 1% THD, 1 k ohm load)	124.2 dB
Equivalent Output Noise (A-weighted)	28.0 dB SPL
Signal to Noise Ratio (referenced at 94 dB SPL)	66.0 dB
Dynamic Range at 1 k ohm load	96.2 dB 100 dB at 0 gain
Common Mode Rejection	45.0 dB minimum.
Preamplifier Output Clipping Level (1% THD)	-6.0 dBV (0.5 V) -12 dBV at 0 gain
Polarity	Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector
Power Requirements	11 to 52 Vdc phantom, 2.0 mA
Environmental Requirements	Operating Temperature Range: -18 to 57 degrees C (0 to 135 degrees F) Relative Humidity: 0 to 95%