| Type | Condenser (electret bias) |
| Frequency Response | 50 to 17000 Hz |
| Polar Pattern | MX395/C: Cardioid |
| Output Impedance | EIA Rated at 150 Ohms (170 Ohms actual) |
| Output Configuration | Active balanced |
| Sensitivity (at 1 kHz , open circuit voltage) | Cardioid: -35 dBV/Pa (18 mV) |
| Maximum SPL (1 kHz at 1% THD, 1 kilohms load) | Cardioid: 121 dB |
| Equivalent output Noise (A-weighted) | Cardioid: 28 dB SPL |
| Signal-to-Noise Ratio (referenced at 94 dB SPL at 1 kHz) | Cardioid: 66 dB |
| Dynamic Range (1 kilohm load at 1 kHz) | Cardioid: 93 dB |
| Common Mode Rejection (10 Hz - 100 kHz) | 45 dB minimum |
| Preamplifier output Clipping level (1% THD) | -8 dBV (0.4 V) |
| Polarity | 3-Pin XLR: Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector. |
| Weight | Net: 0.30 lbs
Packaged: 0.825 lbs.
|
| Logic Connections | Spec Info A4LED IN: Active low (≤1.0V), TTL compatible. Absolute maximum voltage: -0.7V to 50V |
| Environmental Conditions | Operating Temperature: -18 to 57 deg. C (0 to 135 deg. F)
Storage Temperature: -29 to 74 deg. C (-20 to 165 deg. F)
Relative Humidity: 0 to 95%
|
| Power Requirements | 11 - 52 Vdc phantom, 2.0 mA |
