Shure MX418SE/N 18" Standard Gooseneck Condenser Microphone (No Cartridge)

Shure MX418SE/N 18" Standard Gooseneck Condenser Microphone (No Cartridge)
Camcor Item No.	136017419
Mfg. Part No.	MX418SE/N

Shure MX418SE/N Microflex® Standard Gooseneck microphone is fully adjustable and designed for easy replacement and flexibility with interchangeable cartridges: Cardioid, Supercardioid, and Omnidirectional polar patterns are available and can be switched out as needed. MX418SE/N is an excellent choice for use in houses of worship, courtrooms and conference centers. Plus, the condenser cartridges fit every model in the Microflex product line for enhanced convenience and consistent sound.

MX418SE/N includes 18" In-Line Preamp, Shock & Flange Mount, 10' Side- (or Bottom-) Exit Cable, Snap-Fit Foam Windscreen. Microphone cartridge not included.

Features

18" In-Line Preamp

10' Side- (or Bottom-) Exit Cable

Snap-Fit Foam Windscreen

Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum

Interchangeable cartridges provide the right polar pattern for every application

Balanced, transformerless output for increased immunity to electromagnetic hum and RF interference over long cable runs

Shock mount provides over 20 dB isolation from surface vibration noise

Locking flange mount for permanently securing microphone to lecterns, pulpits, or conference tables

Specifications

Frequency Response	50 to 17,000 Hz
Output Impedance	180 ohms actual (EIA rated at 150 ohms)
*Sensitivity (At 1,000 Hz, open circuit voltage)**
Maximum SPL (1 kHz at 1% THD, 1 kilohm load)
Equivalent Output Noise (A-weighted)
Signal to Noise Ratio (referenced at 94 dB SPL)
Dynamic Range at 1 kilohm load 96.2 dB	100 dB at 0 gain
Common Mode Rejection	45.0 dB minimum
Preamplifier Output Clipping Level (1% THD)	-6.0 dBV (0.5 V) -12 dBV at 0 gain
Polarity	Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector
Power Requirements	11 to 52 Vdc phantom, 2.0 mA
Environmental Requirements	Operating Temperature Range: -18 to 57 degrees C (0 to 135 degrees F) Relative Humidity: 0 to 95%