Shure MX412S/N 12" Standard Gooseneck Condenser Microphone (No Cartridge)

Shure MX412S/N 12" Standard Gooseneck Condenser Microphone (No Cartridge)
Camcor Item No.	136017421
Mfg. Part No.	MX412S/N

Shure MX412S/N standard gooseneck condenser microphone is fully flexible and adaptable to several cartridge options. Cardioid, Supercardioid and Omnidirectional polar patterns allow for a wide variety of uses.

MX412S/N includes a 12" attached XLR Preamp, Shock & Flange Mount, Snap-Fit Foam Windscreen, Mute Switch, LED Indicator. Microphone cartridge not included.

Features

12" Attached XLR Preamp

Mute Switch, LED Indicator

Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum

Interchangeable cartridges provide the right polar pattern for every application

Balanced, transformerless output for increased immunity to electromagnetic hum and RF interference over long cable runs

Shock mount provides over 20 dB isolation from surface vibration noise

Locking flange mount for permanently securing microphone to lecterns, pulpits, or conference tables

Snap-fit foam windscreen

Specifications

Frequency Response	50 to 17,000 Hz
Output Impedance	180 ohms actual (EIA rated at 150 ohms)
*Sensitivity (At 1,000 Hz, open circuit voltage)**
Maximum SPL (1 kHz at 1% THD, 1 kilohm load)
Equivalent Output Noise (A-weighted)
Signal to Noise Ratio (referenced at 94 dB SPL)
Dynamic Range at 1 kilohm load 96.2 dB	100 dB at 0 gain
Common Mode Rejection	45.0 dB minimum
Preamplifier Output Clipping Level (1% THD)	-6.0 dBV (0.5 V) -12 dBV at 0 gain
Polarity	Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector
Power Requirements	11 to 52 Vdc phantom, 2.0 mA
Environmental Requirements	Operating Temperature Range: -18 to 57 degrees C (0 to 135 degrees F) Relative Humidity: 0 to 95%