Furman POWER SEQUENCER at Camcor.com

Furman POWER SEQUENCER
In Stock
Camcor Item No.	481026831
Mfg. Part No.	M-8S

Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system. Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.

Specifications

General Information
Manufacturer	Furman
Brand Name	Furman
Product Model	M-8S
Product Type	Line Conditioner
Technical Information
Protection Type	Surge
Plug/Connector Type	NEMA 5-15P
Receptacle Type	AC Power
Receptacles Detail	9 x AC Power
Power Description
Input Voltage	120 V AC
Output Voltage	30 V DC
Maximum Line Current	15 A
Surge Energy Rating	225 J
Physical Characteristics
Cord Length	10 ft
Height	1.8"
Width	19"
Depth	8.8"
Miscellaneous
Additional Information	Standard level AC Surge Protection : Merit Class (sacrificial) Spike Protection Mode : Line to neutral, zero ground leakage Max Continuous Operating Voltage : 130V RMS Max Clamp Voltage : 500 Volts Peak Peak Impulse Current : 12,000 Amps AC Filtering : Standard level Pi LCR Filter Noise Attenuation : >26dB, 100 Khz to 1 MHz Operating Temperature Range : 5C (40F) to 40C (105F) degrees Humidity Range : <90% rH (Relative Humidity) Rocker Switch : Front panel, Sequence (ON, OFF) Thermal Circuit Breaker : Front panel, push to reset Front Panel Indicators : Delay 1, Delay 2, Delay 3, Power, Protection OK Rear Panel DIP Switches : 12V Mode On/Off, GND Mode On, Momentary/Maintained Potentiometer : Rear panel, time calibration fine tune delay adjust Remote Terminal : Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring) Safety Agency : C/CSA/US
Compatibility	Rack
Warranty
Limited Warranty	3 Year